Procedure
1. Back up all server data.
2. Observe the LED status of the drive and determine if it can be removed.
3. Remove the drive:
a. Push the Power button.
The Do Not Remove button illuminates and flashes.
b. Wait until the flashing stops and the Do Not Remove button is no longer illuminated.
c. Push the Do Not Remove button and then remove the drive.
Installing a uFF drive and SCM drive carrier
IMPORTANT:
Not all drive bays support the drive carrier. To find supported bays, see the server QuickSpecs.
Procedure
1. If needed, install the uFF drive into the drive carrier.
2. Remove the drive blank.
3. Install the drives.
Installing a uFF drive and SCM drive carrier 49
To Next Page
Loading...
