10. Install the riser provided in the kit in the primary PCI riser cage.
11. Observe the following:
NOTE:
The following information describes the standard cable routing for this component. For more
information on optional cable routing, see the Hewlett Packard Enterprise DL360 Gen10 Server
cabling matrix on the Hewlett Packard Enterprise website (http://www.hpe.com/info/
CablingMatrixGen10).
12. Route and connect the data cable.
13. Install the primary PCI riser cage.
14. Install the access panel (Installing the access panel on page 25).
15. Install the server in the rack.
16. Connect each power cord to the server.
56 Hardware options installation
To Next Page
Loading...
