a. Extend the server from the rack (Extend the server from the rack on page 24).
b. Remove the server from the rack (Remove the server from the rack on page 25).
6. Remove the access panel (Remove the access panel on page 25).
7. Install the controller.
8. Connect the cables.
Additional cabling options are available. For more information, see the HPE DL360 Gen10 Server cabling
matrix on the Hewlett Packard Enterprise website (http://www.hpe.com/info/CablingMatrixGen10).
• 8 SFF
• 10 SFF SAS/SATA NVMe Combo
Hardware options installation 83
To Next Page
Loading...
