Setup 38
2.
Connect the power cord to the AC power source.
3. Press the router power button.
The LEDs on the router LAN ports flashes on and off for approximately one minute. When the router Alert
LED turns off, proceed to the next step.
For more information on the location of the router LEDs and their behavior during the initial router
configuration process, see the router documentation.
4. Log in to the router management interface page and run the setup wizard.
For detailed instructions for this step, see the Quickstart document that shipped with the router.
HP PS1810-8G Switch setup procedures
For deployments requiring more than four network ports on the router, HP recommends adding the HP
PS1810-8G Switch.
Mount the switch with the server
To Next Page
Loading...
