Hardware options installation 52
c.
Secure the excess length of the cable in the top chassis cable clip.
10. Install the chassis cover (on page 18).
11. Connect the power cord to the server.
12. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
Optical drive option
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP website (http://www.hp.com/go/qs).
To install the component:
1. Power down the server (on page 14).
2. Disconnect the power cord from the AC source.
3. Disconnect the power cord from the server.
4. Remove the chassis cover (on page 18).
To Next Page
Loading...
