To Next Page

To Previous Page

Removal and replacement procedures 30

Remove the drive.

To replace the component, reverse the removal procedure.

Hot-plug power supply

CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless

all bays are populated with either a component or a blank.

To remove the component:

1. Power down the server (on page 26).

WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or

power supply blank to cool before touching it.

2. Remove the power supply.

Power redundancy requires the presence of two power supply modules in the system.

Questions and Answers:

Need help?

Do you have a question about the HP ProLiant ML310e Gen and is the answer not in the manual?

HP ProLiant ML310e Gen Specifications

General

Product Type	Server
Form Factor	Tower
Processor Sockets	1
Memory Slots	4
RAID Support	HP Dynamic Smart Array B120i Controller
Memory	Up to 32GB
Network Controller	HP 1Gb 332i Ethernet Adapter 2 Ports per controller
Operating System Support	Microsoft Windows Server Red Hat Enterprise Linux (RHEL) SUSE Linux Enterprise Server (SLES) VMware