HP ProLiant ML310e Gen - Front System Fan

Removal and replacement procedures 37
7.
Remove the front I/O module.
To replace the component, reverse the removal procedure.
Front system fan
To remove the component:
1. Power down the server (on page 26).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the tower bezel.
4. Remove the access panel ("Access panel" on page 31).
5. Remove the air baffle ("Air baffle" on page 32).
6. Disconnect the fan cable.