Removal and Replacement Procedures
Feet
NOTE: This procedure applies to tower servers only.
To remove the feet:
1. Place the server on its side.
2. Press down on the tab on the foot (1).
3. Slide the foot out of the locking slot and pull it off the chassis (2).
Figure 2-9: Removing the feet
4. Repeat steps 2 and 3 for the other feet.
To replace a foot, slide it back onto the locking slot. Be sure that the foot snaps securely into
the holder. Repeat with the remaining feet.
2-12 HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide
To Next Page
Loading...
