Removal and Replacement Procedures
Rack Bezel
NOTE: This procedure applies to rack servers only.
To remove the rack bezel:
1. Remove the access panel. Refer to “Access Panel” in this chapter.
2. Loosen the internal rack bezel thumbscrews.
Figure 2-12: Loosening the rack bezel thumbscrews
3. Slide the bezel up to release the spools from the keyholes and pull it away from the server.
Figure 2-13: Removing the rack bezel
To replace the rack bezel, reverse steps 2 and 3.
HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide 2-15
To Next Page
Loading...
