Removal and Replacement Procedures
Access Panel
WARNING: To reduce the risk of personal injury from hot surfaces, allow internal
system components to cool before touching them.
To remove the access panel:
IMPORTANT: You must unlock the tower bezel before removing the access panel. Refer to “Front
Bezel” in this chapter.
1. Push the release latch securing the access panel to the chassis (1).
2. While holding the release latch down, slide the access panel back about 1.5 cm (0.6 in),
and then pull it away from the chassis (2).
Figure 2-11: Removing the access panel (rack server)
To replace the access panel, reverse step 2. When the release latch snaps into place, the
access panel is secure.
2-14 HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide
To Next Page
Loading...
