Removal and Replacement Procedures
5. Disconnect the IDE cable from the CD-ROM drive (1).
6. Disconnect the power cable from the CD-ROM drive (2).
Figure 2-36: Disconnecting CD-ROM cables
7. Remove the CD-ROM drive from the chassis.
To replace the CD-ROM drive:
1. Slide the drive halfway into the bay.
2. Connect any required cables to the drive.
3. Slide the CD-ROM drive fully into the bay until it is seated securely.
CAUTION: When routing cables, be sure that the cables are not located where they can
be pinched or crimped.
HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide 2-39
To Next Page
Loading...
