12 Hardware components
Figure 2: Back panel of an OmniCube server with a single CPU
Figure 3: Back panel of an OmniCube server with two CPUs
Table 4: Back panel component descriptions
Callout Component Description
1 Riser 1 Contains PCIe slots 1-3. You can install optional
2x10GbE or 2x1GbE network cards in these slots, as
shown in slot 2, used by guest VMs only.
A system with a single CPU does not contain riser 1. A
plate is installed in place of riser 1.
2 Accelerator Installed in PCIe slot 5 of riser 2, but also occupies
slot 4. The card has two LEDs that continuously glow
green to indicate normal operation.
3 RAID controller RAID Controller for the rear boot drives installed in
PCIe slot 6 of riser 3. The RAID Controller for the front
data disks is a mezzanine card.
To Next Page
Loading...
