HP StorageWorks D2600 User Manual

Is the I/O module fault LED amber?
Possible SolutionsPossible ReasonsAnswer
No action required.Functioning properly.No
• Make sure that the I/O module
is seated properly by pressing
the I/O module firmly into its
bay after the handle has clicked
in place.
CAUTION:
Never remove an I/O
module from the chassis
while the status LED is
green. Removing an
active I/O module can
result in data loss.
• Contact an authorized service
provider for assistance.
• The I/O module is locked.
• The I/O module has failed.
• Other fault condition exists.
Yes
Is the fan LED amber?
ActionsPossible ReasonsAnswers
No action requiredFunctioning properly.No
• Be sure that the fan is undam-
aged and is fully seated.
• Contact an authorized service
provider for assistance.
Fan might not be inserted properly,
might have a damaged connector,
or might have failed.
Yes
D2600/D2700 Disk Enclosure User Guide 57

HP StorageWorks D2600 Specifications

General

Interface	SAS
Host Interface	6 Gb/s SAS
Redundant Power Supplies	Yes
Hot Plug Drives	Yes
Product Type	Disk Enclosure
Supported Drive Type	SAS, SATA
Rack Height	2U
Cooling	Redundant fans
Drive Bays	12
RAID Support	Depends on the controller
Compatible Controllers	HP Smart Array P411, P812
Power Supply	Two hot-plug, redundant power supplies
Weight	48 lb (21.8 kg) (without drives)