Figure 5 Configuring the Environment Settings Using the Remote DKC Control Function (New BCM
Installation)
To configure the environment settings using the Remote DKC Control Function:
1. Set up the storage system.
For details, see the HP StorageWorks P9000 for Business Continuity Manager Software User
Guide.
2. Install Business Continuity Manager.
For details, see “Installing Business Continuity Manager” (page 22).
3. Perform a local scan.
Perform a local scan to create the disk configuration definition file needed for setting the route
list definitions.
For details, see the description about using a local scan to acquire storage system information
in the HP StorageWorks P9000 for Business Continuity Manager Software User Guide.
Overview of environment settings 53
To Next Page
Loading...
