Table 32 Settings to Connect Business Continuity Manager Agents Installed on the Local Site to
P9000 Replication Manager
Remote SiteLocal SitePrefix
DADIDNon Gen'ed
DADID
Route List ID
(Forward
Direction)
DADIDPort Number
LANo specificationROUTE1NY24042ACCOUNT
NY2ROUTE2INFO
The following shows an example of specifying the settings shown in Table 32 (page 74) for
initialization parameters.
SETINIT PORT(24042)
SETINIT MODE(EDIT)
SETINIT LOCK(PREFIX)
/* PREFIX */
SETINIT PREFIX('ACCOUNT','NY', 'ROUTE1',’*’,'LA')
SETINIT PREFIX('INFO','NY','ROUTE2','NY2','LA')
When Business Continuity Manager Agent Is on the Local Site and a Remote Site
This subsection explains how to specify initialization parameters when Business Continuity Manager
agent is on both the local site and a remote site. In such cases, configure the Business Continuity
Manager agents on the local and remote sites so that they can perform local scans for their
respective sites.
The following example configuration is used to explain the specification method.
74 Setting Up the Environment When Linking with P9000 Replication Manager
To Next Page
Loading...
