HP StorageWorks P9000 - 5 Mainframe to Open System (MTO) Character Code Conversion; Overview of Character Code Conversion

Figure 6 Configuring the Environment Settings in an Existing Environment (Upgrade BCM Installation)
To configure the environment settings in an existing environment:
1. Upgrade Business Continuity Manager. For details, see “Upgrading Business Continuity
Manager” (page 46).
2. Create configuration file datasets. These datasets are needed to perform a device scan and
set copy group definitions in P9000 Replication Manager for the first time. Create datasets
for the following configuration files:
• Disk configuration definition file
• Copy group definition file
For details, see “Creating Configuration File Datasets” (page 50).
3. Configure the environment settings for the Business Continuity Manager agent. For details,
see the following sections:
• “Setting the TCP/IP Port Number” (page 58)
• “Setting Up the Security for Business Continuity Manager Agents” (page 58)
• “Setting Up IBM HTTP Server” (page 60)
• “Creating Initialization Parameters” (page 65)
• “Creating a Cataloged Procedure for Startup for the Business Continuity Manager Agents”
(page 77)
4. Start IBM HTTP Server.
5. Start the Business Continuity Manager agent. For details, see the chapter about linking the
Business Continuity Manager agent with P9000 Replication Manager in the HP StorageWorks
P9000 for Business Continuity Manager Software User Guide.
Overview of environment settings 55