HP StorageWorks P9000 - Page 82

Action(s)Error Message and DescriptionError Code
System action: Terminates operation
(Termination code 12).
User action: Check that the code
conversion table specified exists, and then
re-execute.
Cannot find the code conversion table to
customize.
The code conversion table specified with
“-T” or “-t” parameter of the utility does not
exist in the directory where the utility is
executed.
CCNV10E-I
System action: Proceeds to the next
definition statement (Termination code 08).
User action: Check that the value for CODE
matches the type of conversion, and then
re-execute.
CODE statement is wrong value. Operation
is executed with CODE=code.
Wrong value is specified for CODE
statement.
CCNV10F-I
System action: Proceeds to the next
definition statement (Termination code 08).
User action: Re-execute after checking the
following for the code to be customized:
• A shift code is not specified for the
code to be customized.
Size of code (code) to customize is wrong.
Wrong code specified for the code to be
customized.
CCNV10G-I
System action: Operation continues
(Termination code 12).
Failed to generate code conversion table.
Failed to generate code conversion table
due to an unspecified error.
CCNV10H-I
System action: Operation continues with
the first NAME statement as the valid
NAME statement (Termination code 08).
User action: Check the NAME statement
and re-execute with only the desired NAME
statement specified.
Cannot specify more than one NAME
statement.
More than one NAME statement is
specified.
CCNV10I-I
System action: Operation continues with
the first TYPE statement as the valid TYPE
statement (Termination code 08).
User action: Check the TYPE statement and
re-execute with only the desired TYPE
statement specified.
Cannot specify more than one TYPE
statement.
More than one TYPE statement is specified.
CCNV10J-I
System action: Terminates operation
(Termination code 12).
User action: Check the output directory for
the code conversion table, and then
re-execute.
Failed to open file when generating the
code conversion table.
Encountered an error when opening a file
while generating the code conversion
table.
CCNV10K-I
System action: terminates operation
(Termination code 12).
User action: Check the output directory for
the code conversion table, and then
re-execute.
Failed to open the standard code
conversion table.
Encountered an error when opening a file
while generating the standard code
conversion table.
CCNV10M-I
Troubleshooting82