User and Group Management
70 NAS 1000s Administration Guide
Adding a New Group
To add a group:
1. In the Local Groups dialog box, click New.
The Create New Group dialog box is displayed.
Figure 30: Create New Group dialog box, General tab
2. Enter the group name and description.
3. To indicate the user members of this group, click Members. See "Modifying Group
Properties" for procedural instructions on entering group members.
4. After all group information is entered, click OK. The group is added, and the Local
Groups dialog box is displayed again.
Deleting a Group
To delete a group:
1. From the Local Groups dialog box, select the group to delete, and then click Delete.
2. The Delete Group dialog box is displayed. Verify that this is the intended group and then
click OK. The Local Groups dialog box is displayed again.
To Next Page
Loading...
