HP StorageWorks SN6000 User Manual

50
Firmware Group
Firmware Version Active firmware version
Inactive Firmware Version This field does not apply to this switch
Pending Firmware Version Firmware version that will be activated at the next reset
PROM/Flasher Version Installed version of PROM firmware
Services Group
NTP Client Enabled Enables switches to synchronize their time to a centralized
server. Enabled or Disabled.
NTP Server Address The IP address of the centralized NTP server. Ethernet
connection to NTP server is required.
FDMI Enable Fabric Device Management Interface status. If enabled,
device information can be obtained, managed, and saved
through the fabric using Name Service Management Server
functions. If FDMI is Enabled on the entry switch, QuickTools
reports all FDMI information reported by the entry switch.
FDMI HBA Entry Limit Maximum number of HBAs that can be registered with a
switch.
Embedded GUI Enabled QuickTools web applet status. Indicates whether the web
applet on the switch is Enabled or Disabled.
Inactivity Timeout Number of minutes the switch waits before terminating an
idle command line interface (CLI) session. Zero (0) disables
the timeout threshold.
GUI Mgmt Enabled Web applet status. If Disabled, the switch cannot be
managed using the web applet.
Telnet Enabled Telnet client status Enabled or Disabled.
SSH Enabled Secure Shell status. If Enabled, an encrypted data path is
provided for command line interface sessions.
SSL Enabled Secure Sockets Layer status. If enabled, encryption for
QuickTools web applet, Enterprise Fabric Management
Suite, and CIM sessions is provided.
CIM Enabled Common Interface Model status. The CIM agent is based on
the Storage Networking Industry Association (SNIA) Storage
Management Initiative Specification (SMI-S), which is the
standard for SAN management in a heterogeneous
environment.
FTP Enabled FTP status Enabled or Disabled.
Management Server
Enabled
Management server status Enabled or Disabled.
SNMP Enabled SNMP status, Enabled or Disabled.
Call Home Enabled Call Home status. If enabled and configured, switches can
send alerts to pagers and email. Users can configure the
type of events and where the alerts are sent.
Table 8 Switch data window fields (Continued)
Field Description

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English