What does internal firmware failure blink pattern mean on HP StorageWorks SN6000 Switch?
A 2-blink error pattern on your HP Switch indicates that the firmware has failed and the switch must be reset. Momentarily press and release the Maintenance button to reset the switch.
Specifies system and hardware needed for QuickTools.
Set up inter-fabric routing using TR ports and mapping.
Understand zones, aliases, zone sets, and view zoning databases.
Procedures for editing, saving, and restoring zoning configurations.
Access switch status, configuration, and properties.
Create, modify, and manage user accounts on switches.
Configure IP addressing and DNS parameters for network connectivity.
General| Model | SN6000 |
|---|---|
| Port Speed | 8 Gbps |
| Data Transfer Rate | 8 Gbps |
| Form Factor | 1U |
| Fibre Channel | Yes |
| Manageable | Yes |
| Hot-swappable | Yes |
| Redundant Power Supplies | Yes |
| Management | CLI |
| Width | 17.3 in |
| Depth | 44.5 cm |
| Height | 1.7 in |
| Weight | 7.7 kg |
To Next Page
