HP StorageWorks XP10000 Owner's Guide

XP10000 hardware 31
Service Processor (SVP)
The SVP is a blade PC inside the primary rack that does the following:
• Collects performance data on the disk array for diagnostic testing and
analysis; see “Service information messages” (page 58)
• Provides your HP support representative with access to the disk array
• Allows you to manage the disk array using built-in Remote Web
Console software accessed from a web browser on a remote host
Your HP support representative uses the SVP to configure, maintain, and
upgrade the disk array software and hardware.
Note: For extreme availability requirements, an optional second SVP is available.
To manage multiple XP disk arrays, you can install an optional Device
Manager server running optional Command View Advanced Edition
software (page 35).
Disk drives
The primary rack must contain at least four hard disk drives and can contain
up to 60 drives in the R0 basic disk chassis. For more information, see
“Disk drives” (page 33) and Table 2 (page 21).
HP StorageWorks Continuous Track XP
Continuous Track XP is a program in the disk array that detects and reports
problems even before they are noticed by operators and users.
Continuous Track XP “phones home” to the HP Storage Technology Center
(STC), providing:
• Periodic “well” checkups
This checkup records the health of the disk array on a day-to-day
basis. Every 24 hours, Continuous Track XP calls STC (your HP
support representative sets the time of the call). When a successful
connection is made, status and configuration change information is
transferred from the disk array to STC.

HP StorageWorks XP10000 Specifications

General

Brand	HP
Model	StorageWorks XP10000
Category	Disk array system
Language	English