HP StorageWorks XP10000 User Manual

Business Copy XP user guide for the XP10000/XP12000 75
0852 Command Reject. P-VOL and S-VOL are used from
HOST or by CA.
Disconnect from the host, or cancel Continuous
Access XP path.
0880-
08FF
Logical contradiction. Call HP technical support for assistance.
0C70 A P-VOL is not installed. Volumes that are not installed cannot be
processed.
0C71 The P-VOL cannot be used. Call HP technical support to make the P-VOL status
normal.
0C72 The P-VOL is being formatted. Wait until formatting the P-VOL completes.
0C80 The S-VOL is not installed. Volumes that are not installed cannot be
processed.
0C81 The S-VOL cannot be used. Call HP technical support to make the P-VOL status
normal.
0C82 The S-VOL is being formatted. Wait until formatting the S-VOL completes.
0C90 The volume to be Reserved is not installed. Volumes that are not installed cannot be
processed.
0C91 The volume to be Reserved cannot be used. Call HP technical support to make the volume
status normal.
0C92 The volume to be Reserved is being formatted. Wait until formatting the volume completes.
1001 Logical contradiction. Call HP technical support for assistance.
1002 Logical contradiction. Call HP technical support for assistance.
1003 Logical contradiction. Call HP technical support for assistance.
1004 Logical contradiction. Call HP technical support for assistance.
1005 Logical contradiction. Call HP technical support for assistance.
1007 Logical contradiction. Call HP technical support for assistance.
1009 The number of BC pairs exceeded the maximum. Delete some of the pairs.
1010 Logical contradiction. Call HP technical support for assistance.
1011 The number of the volume specified to be a Reserve
volume has already been used for a Reserve
volume.
Change the volume number for specifying a
Reserve volume.
1012 The number of the volume specified to be a Reserve
volume has already been used for a primary BC
volume.
Change the volume number for specifying a
Reserve volume.
1013 The number of the volume specified to be a Reserve
volume has already been used for a hierarchical
control primary volume.
Change the volume number for specifying a
Reserve volume.
1014 The number of the volume specified to be a Reserve
volume has already been used for a hierarchical
control destination volume.
Change the volume number for specifying a
Reserve volume.
1015 The volume specified to be a Reserve volume is not
set as a Reserve volume.
Check volume status.
1016 The volume can appropriately be allocated as an
S-VOL does not exist among Reserve volumes.
Delete any Reserve volume that can be allocated
as an S-VOL.
Table 25 BC error codes (continued)
Error
Code
Description Corrective Action

HP StorageWorks XP10000 Specifications

General

Brand	HP
Model	StorageWorks XP10000
Category	Disk array system
Language	English