76 Business Copy XP (BC) for the XP10000/XP12000
1017 A Reserve volume cannot be set because the max.
number of Reserve volumes was exceeded.
Delete any Reserve volumes.
101E The Reserve volume itself does not exist in the
system.
Set one or more Reserve volumes.
1026 It is impossible to make a pair any more because
the volume that was specified as P-VOL is root
volume already.
Delete some of the pairs of root volume.
1027 It is impossible to make a pair any more because
the volume that was specified as P-VOL is node
volume already.
Delete some of the pairs of node volume.
1028 It is impossible to make a pair because the volume
that was specified as P-VOL is leaf volume already.
Confirm a pair condition.
1029 It is impossible to make a pair because the volume
that was specified as S-VOL is leaf volume already.
Confirm a pair condition.
102E P-VOL is used as source volume for HIHSM. Confirm a matching condition.
102F P-VOL is used as destination volume for HIHSM. Confirm a matching condition.
1030 The specified P-VOL number does not exist. Retry after refreshing the screen.
1031 The specified P-VOL has been set as a Reserve
volume.
Check pair status.
1032 No more pairs can be created for the specified
P-VOL.
Delete any pairs formed by the P-VOL.
1033 The specified P-VOL is not really a P-VOL. Check pair status.
1037 The specified P-VOL has been set as a BC S-VOL. Check pair status.
103A The Pairresync command was issued to a device in
the SMPL status.
Check pair status.
103B It is impossible to make a pair because volume that
was specified as S-VOL is root volume already.
Confirm a pair condition.
103C It is impossible to make a pair because volume that
was specified as S-VOL is node volume already.
Confirm a pair condition.
103D It is impossible for L2 pair to require a split
because L1 pair is not in the split condition.
After making L1 pair a split condition, re-execute.
103E A new pair was created with a P-VOL forming the
CA cooperation pattern.
Place the BC pair in SMPL status, or place the
Continuous Access XP pair that uses the BC S-VOL
as a P-VOL in SMPL status.
103F A pair status cannot be changed to form the CA
cooperation pattern.
Place the Continuous Access XP pair that uses the
BC S-VOL as a P-VOL in PSUE or SMPL status.
1040 The specified S-VOL does not exist. Set one or more Reserve volumes.
1042 S-VOL is used as destination volume for HIHSM. Confirm a matching condition.
1043 The specified S-VOL number has already been
used as that of an S-VOL.
Check pair status.
1044 The specified S-VOL is not a BC S-VOL. Check pair status.
1046 The specified secondary volume is being used as a
CA P-VOL.
Delete the Continuous Access XP pair.
Table 25 BC error codes (continued)
Error
Code
Description Corrective Action
To Next Page
Loading...
Need help?
General
