Tape Drive Installation and Replacement
36 1U Rackmount Tape Enclosure Reference Guide
5. Remove the top panel by turning the latch lock 1 counter-clockwise, lifting
the latch 2, sliding the panel back 3, and lifting it from the enclosure. See
Figure 25.
Figure 25: Removing the top panel
Caution: To avoid the possibility of damaging the tape drive, do not pull the
drive using the front bezel. The drive may be safely pulled forward using the
rear of the drive.
6. Remove the tape drive by pulling up the spring-loaded button 1 on the rear of
the right mounting rail. Slide the assembly forward and lift from the enclosure
2. See Figure 26.
15107
1
2
3
To Next Page
Loading...
Need help?
General