7. Replace the cover, as described in the appropriate HPE ProLiant Maintenance and Service
guide, and power on the HPE StoreOnce Backup system.
8. Once rebooted, the HPE StoreOnce Backup system will identify the new RAID controller
and will remap the existing disk storage volumes and enclosures to the controller. It will take
5 to 10 minutes for the process to complete. During this time the product will be online but
several warning events will be generated and the GUI Event Log will show errors being
reported and cleared.
9. Use the StoreOnce GUI or StoreOnce CLI to check that the firmware on the new component
is correct. See Upgrading BIOS or hardware firmware (page 9).
NOTE: Note the output at command completion. It will advise if you need a system reboot
or a cold reboot to install the new firmware revision successfully.
22 The HP p1228 RAID controller
To Next Page
Loading...
