HP StoreOnce 4900 - Powering Off the Disk Enclosure

Figure 8 Power button on disk enclosure
2
1
3
4
Powering off the disk enclosure
There are no StoreOnce CLI commands to power off the disk enclosure. Use the Power On/Off
button (1) on the rear of the disk enclosure to power off the unit.
Figure 9 Power button on disk enclosure
After replacing a component
Use the StoreOnce GUI or StoreOnce CLI to check that the firmware on the new component is
correct. See Upgrading BIOS or hardware firmware (page 9).
NOTE: The system reboots after a firmware upgrade, but for some components a cold reboot
is required to complete the process. A message is displayed after the reboot if a cold reboot is
also required. Power down the system, wait the time recommended in the message and then
power on again using the Power On button.
Powering off the disk enclosure 27