TIP: You may need to expand the Location column to identify the bay to which the drive
belongs. (Port identifies which of the two ports on the RAID controller the disk enclosure is
connected to and Box identifies the drawer.)
You can also use the Turn Beacon LED On button that you can see in above screenshot
to ensure that you have the right disk when opening the drawer.
3. Open the hard drive drawer for the relevant drawer. To extend the drawer (3), pull the handle
up (1) and out (2).
Figure 12 Opening the disk drawer
4. To release the carrier handle (2), press the button (1), and remove the failed drive.
Figure 13 Removing the drive
5. Insert the replacement hard drive (1) and close the carrier handle (2).
Replacing a hot plug disk in a disk enclosure 31
To Next Page
Loading...
