to the same network using the appliance's Fully Qualified Domain Name (FQDN). Once connected,
you can run the StoreOnce CLI network commands to optimize your network configuration.
If your network is not DHCP enabled or you have attached to a different network port, you will
need to connect a monitor with keyboard directly to the appliance to configure network settings
manually using the StoreOnce CLI commands. Once configured, you may use the CLI or GUI, as
appropriate, to manage the appliance.
NOTE: The net set wizard StoreOnce CLI command guides you through a series of questions,
using the answers you provide to configure the appliance on your network. See Network
configuration (page 17) for more information and network configuration examples.
Accessing the StoreOnce Management Console
There are three ways of accessing the StoreOnce Management Console:
• Using the StoreOnce Command Line Interface, CLI
• Using the StoreOnce Web Management Interface, GUI
The StoreOnce CLI
The StoreOnce Command Line Interface (CLI) provides a way of administering and monitoring the
system. Some tasks, such as network configuration, snmp configuration and date and time
configuration, can only be carried out from the StoreOnce CLI. See the HP StoreOnce CLI Reference
Guide for more information about the StoreOnce CLI commands and their syntax.
1. StoreOnce CLI commands require an SSH client application (freely available from the internet)
and must be run from a SSH terminal session on a machine that is on the same network as
the StoreOnce appliance:
ssh <username>@<ip_address>
NOTE: They can also be run from a local console (Keyboard and Monitor) attached to the
appliance, for example, if the network is not yet configured.
2. At the prompts provide a User Name and Password (Admin, admin).
The StoreOnce GUI
The HP StoreOnce Management Console is the main interface for:
• Monitoring the status and health of the HP StoreOnce Backup system and all configured backup
devices
• Creating and modifying VTL and NAS StoreOnce backup targets and Catalyst stores (VTL
backup targets may also be created and managed using the StoreOnce CLI)
• Managing replication relationships and housekeeping
To log on to the Management Console using the StoreOnce GUI, use any machine connected to
the same network as the appliance. The HP StoreOnce Backup system uses a secure network
connection.
1. Enter: https://<IP_address>
You may also use the Fully Qualified Domain Name (FQDN)
NOTE: If you use http: in the URL, you are automatically forwarded to the https: secure
network connection.
Accessing the StoreOnce Management Console 15
To Next Page
Loading...
Need help?
General
