HP StoreOnce G3 User Manual

6. You can check the configuration file using:
net show config current
Network Name: current
Network Description: onegigportconfig
Write Protected: no
DNS Servers:16.110.135.51 16.110.135.52
----------------------
Number of Networks:2
----------------------
Network: subnet_one
----------------------
IP Address: 192.168.1.100
Net Mask: 255.255.255.0
Domain Name:
Gateway: 192.168.1.1
Bonding Mode: Not applicable
Default Network: yes
Interfaces:eth0
Command Successful
----------------------
Network: subnet_two
----------------------
IP Address: 192.168.2.100
Net Mask: 255.255.255.0
Domain Name:
Gateway: 192.168.2.1
Bonding Mode: Not applicable
Default Network: no
Interfaces:eth1
Command Successful
Example 3: Adding the 10GbE network (4400 Series only)
For this example, we are assuming you have already created a new configuration file to configure
HA bonding on 1GbE ports and called it bondedports. The subnet name already configured is
bond_net1. We are going to modify it to add a second subnet for the 10GbE network and bond
the 10GbE ports, using network bonding mode 6. We shall call the second subnet bond_net2
1. Make sure both 10 GbE ports are physically connected before starting to re-configure.
2. Connect to the StoreOnce CLI from any client on the same network as admin user (Admin,
admin) and display the port details.
net show ports
3. Add a new subnet called bond_net2 to the bondedports configuration file.
net add subnet <existingconfig> subnet <newsubnetname> [subnet parameters]
#net add subnet bondedports subnet bond_net2 default no
nl
ipaddr 192.168.2.100 netmask 255.255.255.0 gateway 192.168.2.1
nl
domain mycompany.local bonding 6 port eth4,eth5
4. Validate the new configuration.
#net validate config bondedports
5. Activate the new configuration.
#net activate config bondedports
Network configuration examples not using the wizard 27

HP StoreOnce G3 Specifications

General

Brand	HP
Model	StoreOnce G3
Category	UPS
Language	English