HP StoreOnce G3 User Manual

Flashing green: Ongoing network data activity.2. LAN activity status LED indicator
Off: No network data activity or no connection.
Hot-plug drive LEDs
The status of hot-plug hard drives installed in the server is indicated by the drive activity LED indicator
located on the front panel of the server.
Figure 14 Drive LEDs
Steady green: Online, no activity1. Disk Online LED
Flashing green: Ongoing disk activity
Steady amber: Disk has failed
Flashing amber: Predictive disk failure
Off: The disk is not a part of RAID
Steady blue: identifies a specific disk within the unit. The
LED can be beaconed on and off from the StoreOnce
Management Console.
2. Disk beacon LED
Fibre Channel card LEDs
If you have a Fibre Channel version of the HP StoreOnce Backup system, there are three LEDs
adjacent to each FC port.
Table 1 FC card LEDs
ActivityAmber LEDGreen LEDYellow LED
Power Off (OK)OffOffOff
Power on before or after software initialization.
Awaiting HBA software initialization.
OnOnOn
Power on after software initialization. Link not
initialized.
FlashingFlashingFlashing
software fault (OK)Alternately flashingAlternately flashingAlternately flashing
Connected at: 2 (HP D2D4300 Series only) or
1 (all other FC systems) Gb/s
OnOffOff
Activity at 2 (HP D2D4300 Series only) or 1
(all other FC systems) Gb/s (OK)
FlashingOffOff
Connected at 4 (HP D2D4300 Series only) or
2 (all other FC systems) Gb/s
OffOnOff
Activity at 4 (HP D2D4300 Series only) or 2
(all other FC systems) Gb/s (OK)
OffFlashingOff
Connected at 8 (HP D2D4300 Series only) or
4 (all other FC systems) Gb/s
OffOffOn
Activity at 8 (HP D2D4300 Series only) or 4
(all other FC systems) Gb/s
OffOffFlashing
Hot-plug drive LEDs 47

HP StoreOnce G3 Specifications

General

Brand	HP
Model	StoreOnce G3
Category	UPS
Language	English