2
BIOS Settings, (F10) Utility
Using the BIOS Settings
The VIA C7 processors and the CN700 chipset used in the t5135 and t5530 products are supported by
a Phoenix Award BIOS.
Changing BIOS Settings from within the operating system
Some BIOS settings may be changed locally within the operating system without having to go through the
F10 utility
1
. This table identifies the items that can be controlled with this method.
BIOS Setting Default Value Other Values
1st Boot Device USB ATA Flash, Network, Disabled
2nd Boot Device ATA Flash USB, Network, Disabled
3rd Boot Device Network ATA Flash, USB, Disabled
Boot Up NumLock Off On
F12 Boot Enabled Disabled
Integrated Audio Enabled Disabled
Network Controller Enabled Disabled
Serial Port
Enabled
2
Disabled
Parallel Port
Enabled
2
Disabled
PWRON After PWR-Fail Former State On, Off
Wake-on-LAN Enabled Disabled
BIOS Wake Up Disabled Enabled, days of the week & time
NOTE:
1
Settings that can be controlled from the operating system with repset can also be controlled
remotely by sending the client an Altiris job that uses the repset tool to apply the setting changes.
2
For Win CE, displays only Enabled or Disabled status IO Base and IRQ cannot be changed. Enabled is
the same as setting the base/IRQ to 378/IRQ4.
ENWW Using the BIOS Settings 5
To Next Page
Loading...
Need help?
General