If you are running in a Linux environment go to step 3.
2.
If you are running in an MS RIS PXE environment press the F12 key to activate the network service
boot as soon as the DHCP IP information appears on the screen.
If the unit does not boot to the network the server is not configured to PXE.
If you missed the F12 cue, the system will try to boot to the ATA flash that is not present. The message
on the screen will read: ERROR: Non-system disk or disk error. Replace and press any
key when ready.
Pressing any key will restart the boot cycle.
3.
If you are running in a Linux environment an error message will appear on the screen if there is no
Client IP. ERROR: Non-system disk or disk error. Replace and press any key when
ready.
Troubleshooting Flow Charts
Figure 3-1 Initial Troubleshooting, Part 1
ENWW Troubleshooting Flow Charts 19
To Next Page
Loading...
Need help?
General