Setup Utility—Standard CMOS Features
Table 2-3 Setup Utility—Standard CMOS Features
Option Description
Date (mm:dd:yy)
Allows you to set system date
Time (hh:mm:ss)
Allows you to set system time.
IDE Primary Master
Indicates ATA Flash settings.
Halt On
Allows you to select system response of All Errors, No Errors, or All But Keyboard when POST Error
has been detected. Default is All But Keyboard.
Setup Utility—Advanced BIOS Features
Table 2-4 Setup Utility—Advanced BIOS Features
Option Description
Quick Power-on Self
Test
Allows the system to skip certain tests while booting. This will decrease the time needed to boot the
system. Enabled/Disabled. Default is Enabled
1st Boot Device
Select Boot Device Priority. Default is USB.
2nd Boot Device
Select Boot Device Priority. Default is ATA Flash.
3rd Boot Device
Select Boot Device Priority. Default is Network.
Boot Up Numlock
Status
Select power on state for Numlock.
Security Option
Select whether the Password is required every time the system boots or only when you enter Setup.
Default is Setup.
POST Delay (secs)
Set a delay that is added to POST to allow more time to press F10 to enter the Setup Utility. Default
is None.
F12 Boot
Enable/Disable F12 network boot. Default is Enabled.
USB Boot
Enable/Disable USB boot order. Default is Enabled.
8Chapter 2 BIOS Settings, (F10) Utility ENWW
To Next Page
Loading...
Need help?
General