HP T5135 - Compaq Thin Client - Page 80

2.
Insert and tighten the three screws.
Figure E-4 Replacing the metal side cover
To replace the access panel:
1.
Place the access panel on the side of the unit, offset about 12.7–mm (1/2–inch) toward the front of
the unit (1).
2.
Slide the panel toward the rear of the unit until it locks into place (2).
3.
Replace the two screws that secure the access panel to the chassis (3).
Figure E-5 Replacing the side access panel
74 Appendix E Replacing the Battery ENWW