HP x360 310 G2 - Solid-state drive (M.2) removal and replacement

Solid-state drive (M.2)
Description Spare part number
HP Pavilion x360 Convertible models:
●
128 GB, TLC 809555-001
●
128 GB, value 830391-001
HP x360 310 G2 models:
●
256 GB, TLC 824143-001
●
128 GB, TLC 824142-001
●
64 GB, MLC 833656-001
Before removing the solid-state drive, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Top cover on page 29).
5. Disconnect the battery.
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.5 screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Component replacement procedures 35