Connect the disk array
The HP service representative connects the disk array to the host by:
1. Verifying op
erational status of the disk array channel adapters, LD EVs, and paths.
2. Connecting
the Fibre Channel cables between the disk array and the fabric switch
or host.
3. Verifying the ready status of the disk array and peripherals.
Defining the paths
Use Remote Web Console (shown), Command View, or Command View XP AE to define
paths (LUNs) between hosts and volumes in the disk array.
This process is also called “LUN mapping.” In Remote Web Console and Command
View, LUN mapping includes:
• Configuring ports
• Enabling LUN security on the ports
• Creating host groups
• Assigning host bus adapter WWN s to host groups
• Mapping volumes to host groups (by assigning LUNs)
Disk Array XP operating system configuration guide: HP-UX
21
To Next Page
Loading...
