HP XP1024 - Mounting and Verifying the File Systems

Mounting and verifying the file systems
After the mount directories have been created, mount and verify the file system for
each logical volume.
To mount and verify the file systems:
1. Use mount to mo
unt the file system for the volume.
Example
# mount /dev/vg06/lvol1 /AHPMD-LU00
2. Repeat step 1 for each logical volume on the disk array.
If you need to unmount a file s ystem, use the unmount command.
3. Use the bdf comm and to verify that the file systems are correct. The capacity
is listed u
nder Kbytes.
Example
# bdf
Filesystem Kbyt es used av ail %used Mounted on
/ldev/vg0
0/lvol1 59797 59364 0 100% /
:
/ldev/vg06/lvol1 2348177 9 2113350 0% /AHPMD-LU00
4. As a final verification, p er form some basic UNIX operations (for example file
creation, copying, and deletion) on each logical device to make sure that the
devices on the disk array are fully operational.
Example
#cd /AH
PMD-LU00
#cp /bin/vi /AHPMD-LU00/vi.back1
#ls -l
drwxr
-xr-t 2 root root 8192 Mar 15 11:35 lost+found
-rwx
r-xr-x 1 root sys 217088 Mar 15 11:41 vi.back1
#cp vi.back1 vi.back2
#ls -l drwxr-xr-t 2 root root 8192 Mar 15 11:35 lost+found
-rwxr-xr-x 1 root sys 217088 Mar 15 11:41 vi.back1
-rw
xr-xr-x 1 root sys 217088 Mar 15 11:52 vi.back2
Disk Array XP operating system configuration guide: HP-UX
41