7. Create the volume group.
To allocate more than one physical volume to the new volume group, add the other
physical volumes, separated by a space.
Example
# vgcreate /dev/vg06 /dev/dsk/c6t0d0
Volume group "/
dev/vg06" has been successfully created.
Volume group configuration for /dev/vg06 has been saved in
/etc/1vmconf/vg06.conf.
For Logical Unit Size Expansion (LUSE) volumes that contain more than 17
OPEN-8/9 LDEVs or more than 7043 MB (OPEN-8/9*n-CVS), use the –s and
–e physical extent (PE) parameters of the vgcreate command. See LUSE device
parameters.
If you need to d elete a volume group, use the vgremove command (for example,
vgremove /dev/vgnn). If the vgremove command does not work because the
volume group is not active, use the vgexport command (for example, vgexport
/dev/vgnn).
8. Use the vgdisplay c om m a nd to verify that the new directory was created.
9. Use vgdisplay –v to verify that the volume group was created correctly. The –v
option displays the detailed volume group information.
Disk Array XP operating system configuration guide: HP-UX
33
To Next Page
Loading...
Need help?
General
