HP Z32k G3

● Connect one end of an HDMI cable to the HDMI port on the rear of the monitor and the other end to
the HDMI port on the source device.
● Connect one end of a Thunderbolt cable to the Thunderbolt port on the rear of the monitor and the
other end to the Thunderbolt port on the source device. (Use only the HP-approved Thunderbolt
cable provided with the monitor.)
NOTE: The monitor’s Thunderbolt port provides network, data, video, and power delivery (up to
100 W).
The host device must be able to support DisplayPort Alt Mode (video, charging, and USB 3.1)
over the Thunderbolt connector. The host device must also be compatible with USB Type-C-
Thunderbolt™-enabled ports.
12
Chapter 1Getting started