Item Description Status
1 UID button/LED Solid blue = Activated
Flashing blue:
• 1 flash per second = Remote management or firmware
upgrade in progress
• 4 flashes per second = iLO manual reboot sequence initiated
• 8 flashes per second = iLO manual reboot sequence in
progress
O = Deactivated
2
NIC status LED Solid green = Link to network
Flashing green (1 flash per second) = Network active
O = No network activity
3 Health LED Solid green = Normal
Flashing green (1 flash per second) = iLO is rebooting
Flashing amber = System degraded
Flashing red (1 flash per second) = System critical
If the health LED indicates a degraded or critical state, review
the system IML or use iLO to review the system health status.
4 Power On/Standby button and system
power LED
Solid green = System on
Flashing green (1 flash per second) = Performing power on
sequence
Solid amber = System in standby O = No power present
If the system power LED is o, verify the following conditions:
• The facility power is present.
• The power supply is installed and is working correctly.
• The power cord is attached and is connected to a power
source.
• The front I/O cable is connected.
When all four LEDs described in this table flash simultaneously, a power fault has occurred. For more information, see
Power fault LEDs on page 11.
Component identification 9
To Next Page
Loading...
