To Next PageTo Next Page
Need help?Do you have a question about the HPE ProLiant DL325 Gen10 Plus and is the answer not in the manual?
General| Processor Sockets | 1 |
|---|---|
| Maximum Processors | 1 |
| Memory Slots | 16 DIMM slots |
| Form Factor | 1U Rack |
| Processor | AMD EPYC 7002 and 7003 Series |
| Memory | Up to 4TB DDR4 |
| Drive Bays | 8 SFF or 4 LFF |
| RAID Support | HPE Smart Array controllers |
| Network | HPE Ethernet 1Gb 4-port Adapter |
| Power Supply | 800W Platinum, 1600W Platinum |
| Expansion Slots | 3 PCIe 4.0 slots |
| Operating System Support | Windows Server, VMware |
Identifies front panel components, LEDs, buttons, and pull tabs.
Details rear panel components, ports, and status LEDs.
Illustrates system board components, connectors, and switches.
Covers drive box identification, numbering, and drive LED/button status.
Explains PCIe slot specifications and riser board components.
Details fan bay numbering for cooling components.
Procedures for removing/installing the bezel and powering the server on/off.
Covers accessing the rear panel, extending, and removing the server from the rack.
Details procedures for managing inner and outer drive cages.
Covers the installation and removal of the air baffle for proper cooling.
Procedures for installing and removing riser cages and blanks.
Procedure for removing the media bay blank.
Details optional support services offered by HPE for system maintenance.
Covers options for initial server setup and installation procedures.
Step-by-step guide for unboxing, installing options, racking, and initial configuration.
Instructions for updating system firmware and installing operating systems.
Steps for configuring storage arrays and deploying operating systems.
Details space, airflow, and temperature requirements for optimal operation.
Covers electrical power, grounding, and safety requirements for installation.
Lists general warnings for handling the server, heat, and electrical hazards.
Provides warnings for rack installation and handling electrostatic discharge.
Overview of utilities like Active Health System, iLO 5, and QuickSpecs.
Details iLO Federation, RESTful API, InfoSight, and remote support services.
Covers Intelligent Provisioning, UEFI utilities, boot modes, and storage configuration.
Procedures for updating system firmware, drivers, and software using SPP and SUM.
Covers installing the bezel, drives, and drive cages.
Details installing drive cages and upgrading drive configurations (4LFF/8LFF, 8SFF/16SFF).
Details installing secondary low profile and full height PCIe riser cages.
Covers installing Smart Array modular and PCIe plug-in controllers.
Instructions for installing energy packs and expansion boards.
Covers installing SAS expander, M.2 SSD, and Optical Drive options.
Details fan installation and DIMM installation procedures.
Covers installing intrusion detection switch and serial port cable.
Procedure for installing redundant hot-plug power supplies.
General guidelines for connecting and disconnecting server cables.
Illustrates cable routing for LFF and SFF drive models.
Details cable routing for NVMe and mixed drive configurations.
Covers cable routing for optical drives, front I/O, serial ports, and intrusion switches.
Details cable routing for M.2 boards, controller power, and energy packs.
Provides information on the type and handling of the system battery.
Step-by-step instructions for removing and replacing the system battery.
Explains NMI functionality for generating crash dump files for system analysis.
Lists available documentation and resources for troubleshooting server issues.
Details environmental operating conditions and physical dimensions.
Lists specifications for various HPE Flex Slot power supply models.
Lists important HPE websites for information and product details.
Guides for accessing HPE support, downloading updates, and managing entitlements.
Details remote support options and warranty information for HPE products.
Information on regulatory compliance and how to provide documentation feedback.
