6. Install the access panel.
7. Slide the server in the rack.
The installation is complete.
Memory options
IMPORTANT: This server does not support mixing LRDIMMs and RDIMMs. Attempting to mix any combination of
these DIMMs can cause the server to halt during BIOS initialization. All memory installed in the server must be of
the same type.
DIMM population information
For specific DIMM population information, see the DIMM population guidelines on the Hewlett Packard Enterprise website
(https://www.hpe.com/docs/amd-population-rules-Gen10Plus).
Memory speed tables
For specific DDR4 server memory speeds, for HPE servers using AMD processors, see the Hewlett Packard Enterprise
website (https://www.hpe.com/docs/amd-speed-table-Gen10Plus).
Installing a DIMM
Procedure
1. If installed, remove the bezel.
2.
Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
100
Hardware options installation
To Next Page
Loading...
