5. Place the server on a sturdy, level surface.
Removing the inner rack rails
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1.
If installed, remove the bezel.
2.
Power down the server.
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6. For the long chassis, remove three screws on each side.
7. Slide the inner rails towards the front of the chassis and pull them out.
32
Operations
To Next Page
Loading...
