Installing the inner rack rails
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1. Align the holes on the rack rail with the chassis alignment pins and slide the rails against the chassis wall.
2.
For the long chassis, install three screws on each side.
Removing the access panel
CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating the server
in this manner results in improper airflow and improper cooling that can lead to thermal damage.
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Operations
33
To Next Page
Loading...
