HPE ProLiant DL325 Gen10 Plus

5. Install the access panel.
6.
Install the inner rack rails.
7.
Install the server into the rack.
8.
Connect all peripheral cables to the server.
9.
Connect each power cord to the server.
10.
Connect each power cord to the power source.
11.
Power up the server.
12.
If removed, install the bezel.
Removing the air bale
CAUTION: For proper cooling, do not operate the server without the access panel,
bales, expansion slot covers, or
blanks installed. If the server supports hot-plug components, minimize the amount of time the access panel is open.
Procedure
1. If installed, remove the bezel.
2.
Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
Operations
45