9. Install the access panel .
10. Slide the server into the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server .
ResultsResults
The installation is complete.
Installing a tertiary riser cageInstalling a tertiary riser cage
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
T-10 Torx screwdriver
ProcedureProcedure
1. Observe the following alert.
CAUTION:CAUTION: To prevent damage to the server or expansion boards, power down the server and remove all AC power
cords before removing or installing the PCI riser cage.
2. Power down the server.
3. Do one of the following:
Disconnect each power cord from the power source.
To Next Page
Loading...
