Setting up the serverSetting up the server
PrerequisitesPrerequisites
Before setting up the server:
Read the operational requirements for the server:
Operational requirements
Read the safety and compliance information on the HPE website:
http://www.hpe.com/support/safety-compliance-enterpriseproductshttp://www.hpe.com/support/safety-compliance-enterpriseproducts
ProcedureProcedure
1. Unbox the server and verify the contents:
A server
A power cord
Rack-mounting hardware
Documentation
2. (Optional) Install hardware options.
3. Install the server in a rack.
The rack procedures are included with the rack rails.
a. Connect devices, cables, and cords to the server.
b. Secure cables using the cable management arm.
4. Decide how to manage the server:
Locally: use a KVM switch or a connect a keyboard, monitor, and mouse.
Remotely: connect to the iLO web interface using remote console.
a. Verify the iLO management port is connected to a secure network.
b. Using a browser, navigate to the iLO web interface, and then log in.
Note the following:
The hostname is on the serial pull tab.
If a DHCP server assigns the IP address, the IP address appears on the boot screen.
If a static IP address is assigned, use that IP address.
The default login credentials are on the serial label pull tab.
c. In the side navigation, click the Remote Console & Media link, and then launch a remote console.
5. Press the Power On/Standby button.
For remote management, use the iLO virtual power button.
SubtopicsSubtopics
Operational requirementsOperational requirements
Rack warnings and cautionsRack warnings and cautions
Server warnings and cautionsServer warnings and cautions
To Next Page
Loading...
