Use a portable field service kit with a folding static-dissipating work mat.
If you do not have any of the suggested equipment for proper grounding, have an authorized reseller install the part.
For more information on static electricity or assistance with product installation, contact an authorized reseller.
OperationsOperations
SubtopicsSubtopics
Power up the serverPower up the server
Power down the serverPower down the server
Extend the server from the rackExtend the server from the rack
Remove the server from the rackRemove the server from the rack
Remove the bezelRemove the bezel
Remove the access panelRemove the access panel
Installing the access panelInstalling the access panel
Remove the fan cageRemove the fan cage
Install the fan cageInstall the fan cage
Remove the air baffle or midplane drive cageRemove the air baffle or midplane drive cage
Install the air baffleInstall the air baffle
Remove the riser cageRemove the riser cage
Releasing the cable management armReleasing the cable management arm
Accessing the Systems Insight DisplayAccessing the Systems Insight Display
Power up the serverPower up the server
About this taskAbout this task
To power up the server, use one of the following methods:
Press the Power On/Standby button.
Use the virtual power button through iLO.
Power down the serverPower down the server
Before powering down the server for any upgrade or maintenance procedures, perform a backup of critical server data and programs.
IMPORTANT:IMPORTANT:
When the server is in standby mode, auxiliary power is still being provided to the system.
To power down the server, use one of the following methods:
To Next Page
Loading...
