8. Install the tertiary riser cage:
ResultsResults
The installation is complete.
Installing an accelerator or GPUInstalling an accelerator or GPU
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
T-30 Torx screwdriver
T-10 Torx screwdriver
High-performance heatsinks must be installed with this option.
About this taskAbout this task
An accelerator or GPU can be installed into the primary, secondary, or tertiary position. This procedure shows an installation in the
secondary position.
ProcedureProcedure
1. Observe the following alert.
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCIe slots have either
an expansion slot cover or an expansion board installed.
2. Power down the server .
3. Remove all power:
a. Disconnect each power cord from the power source.
To Next Page
Loading...
