HPE ProLiant DL380 Gen11

2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Install the chassis intrusion detection switch.
6. Install the access panel .
7. Slide the server into the rack.
8. Connect each power cord to the server.
9. Connect each power cord to the power source.
10. Power up the server .
Trusted Platform Module 2.0Trusted Platform Module 2.0 guidelines guidelines
HPE ProLiant DL380 Gen11 Server User Guide 147